Vertical and decline shaft sinking - good practices in technique and technology : International Mining Forum 2015, 23-27 February 2015 Cracow, Poland PDF
Preview Vertical and decline shaft sinking - good practices in technique and technology : International Mining Forum 2015, 23-27 February 2015 Cracow, Poland
INTERNATIONAL MINING FORUM 2015 TThhiiss ppaaggee iinntteennttiioonnaallllyy lleefftt bbllaannkk 23–27 FEBRUARY 2015 CRACOW, POLAND Vertical and Decline Shaft Sinking – Good Practices in Technique and Technology International Mining Forum 2015 Edited by Jerzy Kicki AGH University of Science and Technology, Cracow, Poland Polish Academy of Sciences, Mineral and Energy Economy Research Institute, Cracow, Poland Eugeniusz J. Sobczyk Polish Academy of Sciences, Mineral and Energy Economy Research Institute, Cracow, Poland Pawe(cid:225) Kami(cid:276)ski AGH University of Science and Technology, Cracow, Poland CRC Press/Balkema is an imprint of the Taylor & Francis Group, an informa business © 2015 Taylor & Francis Group, London, UK Typeset by Krzysztof Stachurski Printed and bound in Poland All rights reserved. No part of this publication or the information contained herein may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, by photocopying, recording or otherwise, without written prior permission from the publishers. Although all care is taken to ensure integrity and the quality of this publication and the information herein, no responsibility is assumed by the publishers nor the author for any damage to the property or persons as a result of operation or use of this publication and/or the information contained herein. Published by: CRC Press/Balkema P.O. Box 447, 2300 AK Leiden, The Netherlands e-mail: [email protected] www.crcpress.com – www.taylorandfrancis.co.uk – www.balkema.nl ISBN: 978-1-138-02820-3 (Hardback) ISBN: 978-1-315-68383-6 (eBook PDF) International Mining Forum 2015, Kicki et. al. (eds) (cid:164) 2015 Taylor & Francis Group, London, UK. ISBN 978-1-138-02820-3 Table of Contents Preface VII Organization IX Lectures Future Trends in Shaft Development 1 E. Neye, W. Burger, A. Frey, D. Petrow-Ganew, Benjamin Künstle Investment Costs Comparison of Shafts and Declines 13 Branko Gluš(cid:254)evi(cid:252), (cid:253)edomir Belji(cid:252), Zoran Gligori(cid:252) Two-Dimensional Raise-Bore Hole Stability and Support 25 Assessment for the Victoria Project in Ontario, Canada M. Jakubowski, M. Moskwa Conditions of Deformation Prediction in the Shaft 33 A. Kwinta State-of-the-Art in Blind Shaft Drilling for Shaft Sinking 45 in the Coal-Mining Industry in China Song Haiqing, Yao Zhishu, Cai Haibing Vertical Shaft Sinking for Underground 65 Transportation Purposes in Slovenia Marko Ranzinger, Marjan Hudej Freezing Method as the Optimal Way of Rock Mass 79 Treating in Polish Copper Mines S(cid:225)awomir Fabich, Jacek Kulicki, S(cid:225)awomir (cid:285)wito(cid:276) About the Application of Conventional and Advanced Freeze 89 Circle Design Methods for the Ust-Jaiwa Freeze Shaft Project Nikolai Hentrich, Juergen Franz Static Calculations of Mine Shaft Linings 105 in Poland (Selected Problems) A. Wichur, K. Frydrych, P. Kami(cid:276)ski The Construction of Shafts in the Copper Fields in the Conditions 115 of the Fore-Sudetic Monocline as Exemplified by the SW-4 Shaft Wojciech Chojnacki, S(cid:225)awomir Fabich, Tadeusz Rutkowski Underground Deposit Exploitation – Bontang Project 131 Janusz Olszewski, Pawe(cid:225) Wójcik, Janusz Rusek V Deepening the JANINA VI Shaft 143 Jaros(cid:225)aw Jankowski, Jacek Mika, Mariusz Gierat Vertical Position Identification of the Machine Vision System 157 in the Mineshaft for the Purposes of Diagnostic Image Processing of the Mineshaft Lining Surface Henryk Kleta, Adam Heyduk, Jaros(cid:225)aw Joostberens Sinking of 1 Bzie Shaft in Difficult Hydrogeological 167 Conditions with the Application of Combined Lining and High-Performance Concretes Daniel Wowra, Tomasz Sanocki, Mariusz Wojtaczka Repair of Shaft Brick Lining within Clay-Stone Zone 177 and Proposal of Alteration of the Polish Standard PN-G-14002:1997 Roland Bobek, Tomasz (cid:285)led(cid:296), Adam Ratajczak, Wojciech Lekan, Piotr G(cid:225)uch Application of Steel Segments in the Reinforcement 187 of Shaft Lining at a Section of Sandwater Area Aleksander Wardas, Wojciech Lekan, Piotr G(cid:225)uch VI International Mining Forum 2015, Kicki et. al. (eds) (cid:164) 2015 Taylor & Francis Group, London, UK. ISBN 978-1-138-02820-3 Preface The International Mining Forum is a meeting of scientists and professionals who, together with the organizers, establish ambitious aims to confront ideas and experiences, evaluate implemented solu- tions, and discuss new ideas that might change the image of the mining industry. The gained technical and technological experience allowed for development of design methods and improvement of technology. In particular it was related with shaft lining design methods. The present research try to explain these problems to designers, including demonstration that design of underground excavations lining (particularly shaft lining) should be considered as a process of mod- ifications of procedures accompanying gathering knowledge about properties of the rock mass, in- cluding lining material. The International Mining Forum is an event accompanying the School of Underground Mining, organized since 1992 under the auspices of AGH – University of Science and Technology and the Institute of Mineral Economy and Energy of the Polish Academy of Sciences of Cracow. The topics presented during the session will be related to the implementation and operation of shaft facilities. Each of the interesting presentations will be in the range of discussion topics, such as geological and hydrogeological conditions and the technical operation of shafts, overview of con- struction technology, basic issues related to the design process of sinking and shafts lining, direc- tions aimed at modernizing the technologies of sinking. The organizers would like to express their gratitude to all persons, companies and institutions, who contributed to bringing the Forum into being. We hope that the Forum will contribute to the exchange of interesting experiences and establish- ing new acquaintances and friendships. Jerzy Kicki Chairman of the IMF 2015 Organizing Committee VII TThhiiss ppaaggee iinntteennttiioonnaallllyy lleefftt bbllaannkk International Mining Forum 2015, Kicki et. al. (eds) (cid:164) 2015 Taylor & Francis Group, London, UK. ISBN 978-1-138-02820-3 Organization Organizing Committee: Jerzy Kicki (Chairman) Jacek Jarosz (Vice-Chairman) Eugeniusz J. Sobczyk Artur Dyczko Dominik Galica Rafa(cid:225) Polak Micha(cid:225) Kopacz Pawe(cid:225) Kami(cid:276)ski Advisory Group: Volodymyr Bondarenko, professor (National Mining University of Dnipropetrovsk, Ukraine) Alfonso Carvajal (Universidad de La Serena, Chile) Piotr Czaja, professor (AGH University of Science and Technology, Poland) Jozef Dubi(cid:276)ski, professor (Central Mining Institute, Poland) Roman Dyczkowsky professor (National Mining University of Dnipropetrovsk, Ukraine) Jaroslav Dvoracek, professor (Technical University VSB, Czech Republic) Eugeniusz Mokrzycki, professor (Polish Academy of Sciences, Mineral and Energy Economy Research Institute, Cracow, Poland) Jacek Paraszczak, professor (Laval University, Quebec City, Canada) Anton Sroka, professor (Polish Academy of Sciences, The Strata Mechanics Research Institute, Cracow, Poland) Mladen Stjepanowic, professor (University of Belgrade, Republic of Serbia) Antoni Tajdu(cid:286), professor (AGH University of Science and Technology, Poland) Yuan Shujie (Anhui University of Science and Technology, Huainan, Anhui, China) IX
The list of books you might like
