Table Of Content

VACUUM CLEANER OWNER'S MANUAL SPECIFICATION Model RC-L381 Rating 220~240V/50Hz Watts MAX 1800W Weifhts(net) 4.7kg Dimension (LxWxH) 383 X 269 X 265mm Cord length 5m DESCRIPTION AND OPERATION HOSE CONNECTION SUCTION CONTROL POWER CONTROL SWITCH ON/OFF SWICH CORD REWIND BUTTON • Connecting the hose : insert • Disconnecting the hose: press • The suction power control at • Adjust the suction power by • T urn the unit off(on) by • Rewind the power cord by the hose firmly into the hose the button and pull the hose the hand grib enables you to rotating the swich on the unit pressing the ON/OFF pressing the cord rewind inlet ("Click") out of the vacuum cleanet. control suction power. switch button on the unit. button. PIPE CONNECTION DUST METER DUST METER • When the color of the dust meter is changed to RED for long time, change the dust bag. • To connect the nozzle, hold the tubes and the handle: insert the narrowed section into the wide section. PRACTICAL PARKING STORAGE Brush clip Rest WIDE SUCTION NOZZLE COMBI CREVICE NOZZLE • Cleaning for a while, you • I f you want to store the can place the brush clip cleaner, hitch the brush clip • Use this nozzle for cleaning both into the rest. onto the vacuum cleaner. carpeted and uncarpeted floors. 1 2 CLEANING THE FILTER PRECAUTIONS FOR SAFE USE This vacuum cleaner should only be used for normal dry household dust and dirt. EXHAUST FILTER The manufacturer cannot be responsible for any damage caused by use or operation of the cleaner contrary to these instructions. If the cleaner is wrongly operated for a purpose other than that for which it is intended. no liability can be accepted for any possible damage. • D o not vacuum areas which contain moisture • W hen rewinding the power cord, hold the or water and inflammable matter, needles, plug body before pressing the cord rewind • S witch off. • P ress the clamp position of the • S eparate the filter from the pins, razor blades, matches, cigarette-ends, button to prevent whipping. air outlet cover to discharge the filter case and shake the etc., since they may damage the cleaner or • D o not pull the power cord beyond the air outlet cover forclean up or a dust out of the filter. dust bag or cause a fire. specified length. new replacement. MOTOR PROTECTION FILTER • S witch off and open the • T ake the dust bag holder • S hake the dust out of the cover. with dust bag out from the filter. dust compartment • M ake sure a dust bag and a motor protection • T his product provided with a cable which, if filter are always inserted. damaged must be replaced by a repair shop CHANGING THE DUSTBAG authorized by the manufacturer since special tools are required. • S witch off and open the • T ake the dust bag holder • I nsert the new dust bag into cover. with dust bag out from the the dust bag holder properly dust compartment. as shown in picture. Note: If no dustbag has been placed into the dustbag holder, the cover cannot be closed. 3 4 BEFORE ASKING FOR SERVICE ■ Before Asking for Service, please check each item below if you have trouble with your cleaner. Problem Check Point Measure • Dust bag - If dust bag is dirty, replace it. Suction power is weak. • Pipe or hose - If clogged or blocked, remove the object. The cleaner does not • Power cord - Check if power cord is plugged. work. • on/off switch - C heck if the power switch is turned on. Power cord does not - Pull the power cord out a little and press • Power cord rewind. the cord rewind button. 5