bifen I/T quart front PROOF

39 Pages·2011·2.28 MB·English

INSECTICIDE/TERMITICIDE
PREVENTS AND CONTROLS SUBTERRANEAN TERMITES, DRYWOOD TERMITES,
DAMPWOOD TERMITES, CARPENTER ANTS, AND OTHER WOOD-INFESTING INSECTS
FOLIAR AND SYSTEMIC INSECT CONTROL
FOR USE ON TURFGRASS (INCLUDING, LANDSCAPE ORNAMENTALS, FRUIT AND NUT
TREES AND INTERIOR PLANTSCAPES
For use by professional personnel licensed or registered by the state to apply termiticide. States
may have more restrictive requirements regarding qualifications of persons using this product.
Consult the structural pest control regulatory agency of your state prior to use of this product.
Active Ingredient:
Imidacloprid: 1-1(6-Chloro-3-pyridinyl)methyl]-N-nitro-2-imidazolidinimine ...................................21.4%
Other Ingredients:....................................................................................................................................................78.6%
Total:..............................................................................................................................................................................100.0%
Contains 2 pounds of imidacloprid per gallon. Shake well before using.
KEEPOUTOFREACHOFCHILDREN
CAUTION
PRECAUCION AL USUARIO: Si usted no puede leer o entender ingles, no use este producto
hasta que la etiqueta le haya sido explicada ampliamente.
(TO THE USER: If you cannot read or understand English, do not use this product until the label
has been fully explained to you.)
NETCONTENTS:27.5OZ.
Manufacturedfor:
5903Genoa-RedBluff
Pasadena,TX77507-1041
INSECTICIDE/TERMITICIDE
PREVENTS AND CONTROLS SUBTERRANEAN TERMITES, DRYWOOD TERMITES, DAMPWOOD TERMITES,
CARPENTER ANTS, AND OTHER WOOD-INFESTING INSECTS
FOLIAR AND SYSTEMIC INSECT CONTROL
FOR USE ON TURFGRASS (INCLUDING, LANDSCAPE ORNAMENTALS, FRUIT AND NUT TREES AND
INTERIOR PLANTSCAPES
For use by professional personnel licensed or registered by the state to apply termiticide. States may have more
restrictive requirements regarding qualifications of persons using this product. Consult the structural pest
control regulatory agency of your state prior to use of this product.
Active Ingredient:
Imidacloprid: 1-1(6-Chloro-3-pyridinyl)methyl]-N-nitro-2-imidazolidinimine ...................................................................21.4%
Other Ingredients:...................................................................................................................................................................................78.6%
Total:.............................................................................................................................................................................................................100.0%
Contains 2 pounds of imidacloprid per gallon. Shake well before using.
PRECAUCION AL USUARIO: Si usted no puede leer o entender ingles, no use este producto hasta que la etiqueta le haya sido
explicada ampliamente.
(TO THE USER: If you cannot read or understand English, do not use this product until the label has been fully explained to you.)
Dominion® 2L
INSECTICIDE/TERMITICIDE
PREVENTS AND CONTROLS SUBTERRANEAN TERMITES,
DRYWOOD TERMITES, DAMPWOOD TERMITES, CARPENTER
ANTS, AND OTHER WOOD-INFESTING INSECTS
FOLIAR AND SYSTEMIC INSECT CONTROL
FOR USE ON TURFGRASS
(INCLUDING, LANDSCAPE ORNAMENTALS,
FRUIT AND NUT TREES AND INTERIOR LANDSCAPES)
For use by professional personnel licensed or registered by
the state to apply termiticide. States may have more restrictive
requirements regarding qualifications of persons using this
product. Consult the structural pest control regulatory agency of
your state prior to use of this product.
Active Ingredient:
Imidacloprid: 1-1(6-Chloro-3-pyridinyl)methyl]-N-nitro-2-
imidazolidinimine ............................................................................................21.40%
Other Ingredients ..........................................................................................78.60%
Total ....................................................................................................................100.00%
Contains 2 pounds of imidacloprid per gallon. Shake well before using.
EPA Reg. No. 53883-229 EPA Est. No. 53883-TX-002
KEEp ouT of REaCh of ChIlDREN
CAUTION
pRECauCIoN al uSuaRIo: Si usted no puede leer o entender ingles, no use este producto
hasta que la etiqueta le haya sido explicada ampliamente.
(To ThE uSER: If you cannot read or understand English, do not use this product until the
label has been fully explained to you.)
Control Solutions, Inc.
5903 Genoa-Red Bluff
pasadena, TX 77507-1041
FIRST AID
If • Call a poison control center or doctor immediately for
Swallowed treatment advice.
• Have person sip a glass of water if able to swallow.
• Do not induce vomiting unless told to do so by a
poison control center or doctor.
• Do not give anything by mouth to an unconscious
person.
If Inhaled • Move person to fresh air.
• If person is not breathing, call 911 or an ambulance,
then give artificial respiration, preferably mouth-to-
mouth, if possible.
• Call a poison control center or doctor for further
treatment advice.
If on Skin • Take off contaminated clothing.
or Clothing • Rinse skin immediately with plenty of soap and water
for 15 to 20 minutes.
• Call a poison control center or doctor for treatment
advice.
If in Eyes • Hold eyelids open and rinse slowly and gently with
water for 15 to 20 minutes.
• Remove contact lenses, if present, after the first 5
minutes, then continue rinsing eye.
• Call a poison control center or doctor for treatment
advice.
HOT LINE NUMBER
have the product container or label with you when calling a poison
control center or doctor, or going for treatment. You may also contact
SafetyCall® International [phone] for emergency medical
treatment information.
NOTE TO PHYSICIAN
No specific antidote is available. Treat patient symptomatically.
2
PRECAUTIONARY STATEMENTS
HAZARDS TO HUMANS AND DOMESTIC ANIMALS
CAUTION: harmful if swallowed, inhaled, or absorbed through skin.
avoid contact with skin, eyes, or clothing. avoid breathing spray
mist. Wash thoroughly with soap and water after handling. Remove
contaminated clothing and wash before reuse. Keep children or pets
away from treated area until dry.
Personal Protective Equipment (PPE)
personal protective Equipment (ppE):
applicators and other handlers (mixers and loaders) must wear:
• Long-sleeved shirt and long pants
• Chemical-resistant gloves made of any waterproof material such as
barrier laminate, butyl rubber, nitrile rubber, neoprene rubber, natural
rubber, polyvinylchloride (pVC) or viton.
• Shoes plus socks
In addition: all pesticide handlers must wear protective eyewear when
working in a non-ventilated space or when applying termiticide by
rodding or sub-slab injection.
follow manufacturer’s instructions for cleaning/maintaining ppE. If no
such instructions for washables, use detergent and hot water. Keep and
wash ppE separately from other laundry.
Engineering controls statements: When handlers use closed systems,
enclosed cabs, or aircraft in a manner that meets the requirements listed
in the Worker protection Standard (WpS) for agricultural pesticides [40
CfR 170.240(4)(4-6)], the handler ppE requirements may be reduced or
modified as specified in the WpS.
USER SAFETY RECOMMENDATIONS
User should:
· Wash thoroughly with soap and water after handling and
before eating, drinking, chewing gum, or using tobacco.
· Remove and wash contaminated clothing before reuse.
3
ENVIRONMENTAL HAZARDS
This product is highly toxic to aquatic invertebrates. Do not apply directly
to water, to areas where surface water is present or to intertidal areas
below the mean high water mark. Do not contaminate water when
disposing of equipment washwaters.
This product is highly toxic to bees exposed to direct treatment or
residues on blooming crops or weeds. Do not apply this product or
allow it to drift to blooming crops or weeds if bees are visiting the
treatment area.
This chemical demonstrates the properties and characteristics
associated with chemicals detected in groundwater. The use of this
chemical in areas where soils are permeable, particularly where the
water table is shallow, may result in groundwater contamination.
apply this product only as specified on this label. Extreme care must be
taken to avoid runoff. apply only to soil or other fill substrate that will
accept the solution at the specified rate. Do not treat soil that is water-
saturated or frozen or in any conditions where run-off or movement from
the treatment area (site) is likely to occur.
DIRECTIONS FOR USE
It is a violation of federal law to use this product in a manner inconsistent
with its labeling.
Do not apply this product in a way that will contact workers or other
persons, either directly or through drift. only protected handlers may
be in the area during application. for any requirements specific to your
State or Tribe, consult the agency responsible for pesticide regulation.
4
NON-AGRICULTURAL USE REQUIREMENTS
The requirements in this box apply to uses of this product that
are NoT within the scope of the Worker protection Standard
for agricultural pesticides (40 CfR part 170). The WpS applies
when this product is used to produce agricultural plants on farms,
forests, nurseries, or greenhouses.
Keep children and pets off treated area until dry.
APPLICATION AS A TERMITICIDE
DoMINIoN 2l TERMITICIDE/INSECTICIDE may be used in and along
outside perimeter of structures and building construction to prevent and
control termite infestations.
USE INSTRUCTIONS
for subterranean termite control, specific treatment recommendations
may differ due to regulations, treatment procedures, soil types,
construction practices and other factors. The purpose of chemical
soil treatment for termite control is to establish a continuous chemical
treated zone (horizontal and/or vertical) between the wood and other
cellulose material in the structure and the termite colonies in the soil.
follow all federal, state, and local regulations and treatment standards
for protection of a structure from termites. The establishment of an aerial
or above ground colony may require additional treatments to control the
termites, as well as landscape modifications, and/or structural repairs to
deny termites of a moisture source. use a 0.05% to 0.1% dilution based
on current recommendations. for a typical control situation, a 0.05%
dilution is used. a 0.1% dilution may be used when a severe or persistent
infestation exists.
When treating adjacent to an existing structure, the applicator must
check the area to be treated, and immediately adjacent areas of the
structure, for visible and accessible cracks and holes to prevent any
leaks or significant exposures to persons occupying the structure.
people present or residing in the structure during application must be
advised to remove their pets and themselves from the structure if they
5
see any signs of leakage. after application, the applicator is required
to check for leaks. all leaks resulting in the deposition of termiticide
in locations other than those prescribed on this label must be cleaned
up prior to leaving the application site. Do not allow people or pets to
contact contaminated areas or to reoccupy contaminated areas of the
structure until the cleanup is completed.
Structures that contain wells or cisterns within the foundation of the
structure can only be treated using the treated backfill method described
in the treatment around wells and cisterns section of this label. Consult
state and local specifications for recommended distances of wells from
treated area, or if such regulations do not exist, refer to federal housing
administration Specifications (h.u.D.) for guidance.
MIXING: Refer to MIXING TABLE for correct amount of DoMINIoN
2l TERMITICIDE/INSECTICIDE to be used.
follow this procedure for mixing the termiticide dilution:
1. fill tank to 1/3 full.
2. If using large sprayer, start pump to begin bypass agitation and place
end of treating tool in tank to allow circulation through hose.
3. add appropriate amount of DoMINIoN 2l TERMITICIDE/
INSECTICIDE. add remaining amount of water. let pump run and
allow recirculation through the hose for 2 to 3 minutes.
6
MIXING TABLE FOR DOMINION 2L TERMITICIDE/
INSECTICIDE
EMULSION GALLONS WATER AMOUNT OF
CONCENTRATE IMI 2 LB
0.05% 100 27.5 fl oz
50 13.8 fl. oz.
25 6.9 fl oz
1 0.3 fl oz
0.1% 100 55.0 fl. oz.
50 27.5 fl oz
25 13.8 fl oz
1 0.6 fl oz
IN-LINE INJECTION: use the table below to mix the appropriate
amount of DoMINIoN 2l TERMITICIDE/INSECTICIDE for the desired
injection volume of finished emulsion.
MIXING TABLE - INJECTOR
INJECTOR VOLUME CONCENTRATION
0.3 fl oz/gal 0.05%
0.6 fl oz/gal 0.1%
CoNVERSIoN KEY: 128 fl oz = 1 gal; 16 fl oz = 1 pint; 8 pints = 1 gal;
1 fl oz = 29.5 ml
APPLICATION VOLUME
To provide maximum control and protection against termite infestation,
apply the specified volume of the finished water emulsion and active
ingredient as set forth in the directions for use section of this label. If
7
soil will not accept the labeled application volume, the volume may be
reduced provided there is a corresponding increase in concentration so
that the amount of active ingredient applied to the soil remains the same.
Note: large reductions of application volume reduce the ability to
obtain a continuous barrier. Variance is allowed when volume and
concentration are consistent with label directed rates and a continuous
barrier can still be achieved.
PRE-CONSTRUCTION TREATMENT
Do not apply at a lower dosage and/or concentration than specified on
this label for application prior to installation of the finished grade.
prior to each application, applicators must notify the general contractor,
construction superintendent, or similar responsible party, of the
intended termiticide application and intended sites of application and
instruct the responsible person to notify construction workers and other
individuals to leave the area to be treated during application and until
the termiticide is absorbed into the soil.
CONCRETE SLAB-ON-GROUND OR BASEMENTS: apply an overall
treatment to the entire surface of soil or other substrate to be covered
by the slab including areas to be under carports, porches, basement
floor and entrance platforms. apply at the rate of 1 gallon of solution to
accurately and uniformly cover 10 square feet. If fill under slab is gravel
or other coarse aggregate, apply at the rate of 1.5 gallons or sufficient
volume of solution, to accurately and uniformly cover 10 square feet. In
addition, apply 4 gallons of solution (see APPLICATION VOLUME) per
10 linear feet to provide a uniform treated zone in soil at critical areas
such as along the inside of foundation walls, and around plumbing, bath
traps, utility services, and other features that will penetrate the slab.
after completion of grading, make an application by trenching or
trenching and rodding around the slab or foundation perimeter. Rodding
may be done from the bottom of a shallow trench. When rodding, rod
holes must be spaced in a manner that will allow for a continuous
chemical treated zone, not to exceed 12 inches, to be deposited along
8