Analog Circuit Design: Fractional-N Synthesizers, Design for Robustness, Line and Bus Drivers

391 Pages·2004·27.684 MB·English

by  Woogeun Rhee (auth.), Arthur van Roermund, Michiel Steyaert, Johan H. Huijsing (eds.)

ANALOG CIRCUIT DESIGN
Analog Circuit Design
Fractional-N Synthesizers,
Design for Robustness, Line and Bus Drivers
Edited by
Arthur van Roermund
Eindhoven University ofTechnology, The Netherlands
Michiel Steyaert
KU Leuven, Belgium
and
Johan H. Huijsing
Delft University ofTechnology, The Netherlands
KLUWER ACADEMIC PUBLISHERS
NEW YORK,BOSTON, DORDRECHT, LONDON, MOSCOW
eBookISBN: 0-306-48707-1
Print ISBN: 1-4020-7559-6
©2004 Springer Science + Business Media, Inc.
Print ©2003 Kluwer Academic Publishers
Dordrecht
All rights reserved
No part of this eBook maybe reproducedor transmitted inanyform or byanymeans,electronic,
mechanical, recording, or otherwise, without written consent from the Publisher
Created in the United States of America
Visit Springer's eBookstore at: http://www.ebooks.kluweronline.com
and the Springer Global Website Online at: http://www.springeronline.com
Table of Contents
Preface vii
Part I: Fractional-N Synthesis
A. van Roermund 1
Practical Design Aspects in Franctional-N Frequency Synthesis
W. Rhee 3
Design and Simulation of Franctional-N Frequency
Synthesizers
M. Perrott 27
Monolithic CMOS Fractional-N Frequency Synthesizer Design for
High Spectral Purity
B. De Muer, M. Steyaert 51
A 19mW 2.2GHz Fully Integrated CMOS Sigma Delta Fractional
Synthesiser with 35Hz Frequency Step and Quantization Noise
Compensation
I. Bietti, G. Albasini, E. Temporiti, R. Castello 77
Implementation Aspects of Fractional-N Techniques in
Cellular Handsets
Y. Le Guillou, D. Brunel 97
Fractional-N Phase Locked Loops and it’s Application in the GSM
System
G. Märzinger, B. Neurauter 111
Part II: Design for Robustness
M. Steyaert 129
ESD for Analogue Circuit Design
D. Clarke, A. Righter 131
ESD in Smart Power Processes
G. Croce, A. Andreini, L. Cerati, G. Meneghesso, L. Sponton 169
vi
RF-ESD Co-Design for High Performance CMOSLNAs
P. Leroux, M. Steyaert 207
Improvement of System Robustness through EMC
Optimazation
B. Deutschmann 227
Robustness in Analog Design
M. De Mey 243
Minimizing Undesired Coupling and Interaction in Mixed Signal ICs
T.J. Schmerbeck 255
Part III: Line and Bus Drivers
J. Huijsing 273
Looking to/for Low Power ADSL Drivers in the DSLAM
E. Moons 275
Class-AB Low-Distortion Drivers for ADSL
T. Ferianz 291
Class D Self-Oscillating Line Drivers
T. Piessens, M. Steyaert 309
Class G/H Line Drivers for xDSL
J. Pierdomenico 333
The USB 2.0 Physical Layer: Standard and Implementation
G. den Besten 359
Backplane Transceivers
K. Tam, W. Ellersick, R. Soenneker 379
PREFACE
This book contains the revised and extended tutorials that 18 experts have
presented at the workshop on Advances in Analog Circuit Design
(AACD) held at 15-17 April 2003, in Graz, Austria. The book comprises
three parts, one per topic, each with 6 tutorial contributions. The three
topics are:
Fractional-N Synthesis;
Design for Robustness;
Line and Bus Drivers.
Each topic is introduced with a foreword by the chairman of the day,
respectivelyArthur van Roermund, Michiel Steyaert, and Han Huijsing.
Together, they form the permanent program committee of AACD. The
local organising committee of the workshop was formed this year by
Herbert Grünbacher(workshop chairman) from Carinthia Tech Institute,
Villach, Austria; Wolfgang Pribyl from Austriamicrosystems; and Franz
Dielacher from Infineon Technologies.
This book is number 12 in the series called Analog Circuit Design. The
topics discussed in previous issues are:
AACD 2002 Spa (Belgium)
Structured Mixed-Mode Design
Multi-Bit Sigma-Delta Converters
Short-Range RF Circuits
AACD 2001 Noordwijk (The Netherlands)
Scalable Analog Circuits
High-Speed D/A Converters
RF Power Amplifiers
AACD 2000 Munich (Germany)
High-Speed A/D Converters
Mixed-Signal Design
PLLs and Synthesizers
AACD 1999 Nice (France)
XDSL and Other Communication Systems
RF-MOST Models and Behavioural Modelling
Integrated Filters and Oscillators
viii
AACD 1998 Copenhagen (Denmark)
1-Volt Electronics
Mixed-Mode Systems
LNAs and RF Power Amps for Telecom
AACD 1997 Como (Italy)
RF A/D Converters
Sensor and Actuator Interfaces
Low-Noise Oscillators, PLLs and Synthesizers
AACD 1996 Lausanne (Swiss)
RF CMOS Circuit Design
Bandpass SD and Other Converters
Translinear Circuits
AACD 1995 Villach (Austria)
Low Noise/Power/Voltage
Mixed-Mode with CAD Tools
Voltage, Current and Time References
AACD 1994 Eindhoven (The Netherlands)
Low Power, Low Voltage
Integrated Filters
Smart Power
AACD 1993 Leuven (Belgium)
Mixed-Mode A/D Design
Sensor Interfaces
Communication Circuits
AACD 1992 Scheveningen (The Netherlands)
Opamps
ADC
Analog CAD
We hope that also the current book in this series will provide a valuable
contribution to our Analog Circuit Design community.
Arthur van Roermund
PRACTICAL DESIGN ASPECTS IN
FRACTIONAL-N FREQUENCY SYNTHESIS
Woogeun Rhee
IBM Thomas J. Watson Research Center
Yorktown Heights, NY, USA
Abstract
The objective of this work is to present practical design consideration
of fractional-N frequency synthesis focusing on different aspects
from integer-N frequency synthesizer design. In this work, a frac-
tional-Nfrequency synthesis technique for high spectral purity is pri-
marily considered. The fractional-N synthesizer offers several
advantages over integer-N synthesizers and conventional fractional-
N synthesizers. However, superior performance of the fractional-
N synthesizer can be possibly limited by noise coupling, nonlinearity,
and out-of-band phase noise performance. Design efforts and system
perspectives both for the modulator and the PLL are needed to
overcome those issues. System and circuit design aspects in frac-
tional-N synthesizer design have been addressed followed by exper-
imental hardware results.
1. Introduction
The demand for low-cost high-performance frequency synthesizers is growing as
wireless systems are diversified. High data-rate systems such as general packet
radio service (GPRS) need agile frequency switching and require lower in-band
phase noise to maintain the same integrated phase error with wider loop
bandwidth. Standard frequency synthesizers based on a PLL have difficulties in
meeting various specifications due to the fundamental trade-off between loop
bandwidth and channel spacing. The circuit noise floor of the synthesizer and
spurious tones can be suppressed by narrowing the PLL bandwidth, but the
narrowband PLL suffers from long settling time. The narrow loop bandwidth also
3
A. van Roermund et al. (eds.), Analog Circuit Design, 3-26.
© 2003 Kluwer Academic Publishers. Printed in the Netherlands.
4
put stringent requirement for the VCO noise performance. Therefore, there is a
trade-off to determine the synthesizer performance in terms of the phase noise, the
spurious tone, and the settling time as illustrated in Fig. 1. On the other hand, a
fractional-N technique provides wide bandwidth with narrow channel spacing and
alleviates PLL design constraints for phase noise and reference spur. The inherent
problem of the fractional-N frequency synthesizer is that periodic operation of the
dual-modulus divider produces spurious tones. Among several spur reduction
methods, the modulation method is primarily considered in this work.
2. Fractional-N Frequency Synthesis
Fractional-N frequency synthesizers are PLL-based synthesizers which have a
frequency resolution finer than phase detectorfrequency. The fractional-N method
originally comes from Digiphase technique [1],[2]. Fig. 2 shows the block
diagram of the traditional fractional-N frequency synthesizer. Fractional division
ratio is obtained by periodically modulating the controlinput of the dual-modulus
divider. For example, to achieve an N + 1/4 division ratio or the fractional modulo
of 4, an N + 1 division is done after every three N divisions. The carry of the
accumulator is the sequence of {...000100010001...}, where the N + 1 division
ratio is corresponding to “1”.
5
2.1 Why fractional-N?
Since phase detector frequency can be higher than the frequency resolution, the
fractional-N synthesizers offer several advantages over integer-N synthesizers.
Firstly, the in-band phase noise contribution from the PLL circuits excluding the
VCO is less. For example, to achieve –80 dBc/Hz in-band noise at 2-GHz output
with the phase detector frequency of 200 kHz, the PLL circuit noise at the phase
detector output should be as low as –160 dBc/Hz due to the multiplication factor
of 20log(10 000). When the fractional-N method is used with the phase detector
frequency of 8 MHz, the phase noise requirement of the PLL circuits becomes
only –112 dBc/Hz, which can be easily met even in CMOS. Secondly, the
reference spur performance is less sensitive to the leakage current and to the
charge pump current mismatch. For example, with a 64-modulo fractional-N
technique, the leakage current as high as 10 nA and the 10% mismatch of the
charge pump output currents may not degrade reference spur performance
significantly while they are critical in the integer-N frequency synthesizers [3].
Thirdly, the fractional-N technique offers agile frequency switching with wide
loop bandwidth. Some applications employ narrowband fractional-N synthesizers
simply to alleviate the PLL noise contribution. In that case, faster settling time can
be achieved by using a dynamic bandwidth method. By dynamic bandwidth we
mean that the loop bandwidth is set to be wider than the desired one when the PLL
is in the frequency acquisition mode [4],[5]. With high phase detector frequency,
the loop bandwidth in the transient mode can be set high with less overshoot
problem. The fractional-N technique provides the opportunity of using dynamic
bandwidth methods more effectually.