Characterization of minerals, metals and materials : Proceedings of a symposium sponsored by the Materials Characterization Committee of the Extraction and Processing Division of TMS (The Minerals, Metals & Materials Society)

553 Pages·2012·26.789 MB·English

by  Jiann-Yang Hwang, Sergio Neves Monteiro, Chengguang Bai, John S. Carpenter, Mingdong Cai, Donato Firrao, Byoung-Gon Kim

Characterization of
Minerals, Metals,
and Materials
TIMIS2012
st
141 Annual Meeting & Exhibition
Check out these new proceedings volumes from the
TMS2012 Annual Meeting,
available from publisher John Wiley & Sons:
3rd International Symposium on
High Temperature Metallurgical Processing
CFD Modeling and Simulation in Materials Processing
Characterization of Minerals, Metals, and Materials
Electrometallurgy 2012
Energy Technology 2012: C02 Management and Other Technologies
EPD Congress 2012
International Smelting Technology Symposium
(Incorporating the 6th Advances in Sulfide Smelting Symposium)
Light Metals 2012
Magnesium Technology 2012
Supplemental Proceedings: Volume 1:
Materials Processing and Interfaces
Supplemental Proceedings: Volume 2:
Materials Properties, Characterization, and Modeling
T.T. Chen Honorary Symposium on Hydrometallurgy, Electrometallurgy
and Materials Characterization
To purchase any of these books', please visit www.wiley.com.
TMS members should visit www.tms.org to learn how to get discounts on
these or other books through Wiley.
Characterization of
Minerals, Metals,
and Materials
Proceedings of a symposium sponsored by
the Materials Characterization Committee of
the Extraction and Processing Division of
TMS (The Minerals, Metals & Materials Society)
Held during the
TMS 2012 Annual Meeting & Exhibition
Orlando, Florida, USA
March 11-15,2012
Edited by
Jiann-Yang Hwang
S.N. Monteiro
Chen-Guang Bai
John Carpenter
Mingdong Cai
Donato Firrao
Byoung-Gon Kim
WILEY TIMS
A John Wiley & Sons, Inc., Publication
Copyright © 2012 by The Minerals, Metals, & Materials Society.
All rights reserved.
Published by John Wiley & Sons, Inc., Hoboken, New Jersey.
Published simultaneously in Canada.
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form
or by any means, electronic, mechanical, photocopying, recording, scanning, or otherwise, except as
permitted under Section 107 or 108 of the 1976 United States Copyright Act, without either the prior
written permission of The Minerals, Metals, & Materials Society, or authorization through payment of
the appropriate per-copy fee to the Copyright Clearance Center, Inc., 222 Rosewood Drive, Danvers,
MA 01923, [phone], fax [phone], or on the web at www.copyright.com. Requests to
the Publisher for permission should be addressed to the Permissions Department, John Wiley & Sons,
Inc., 111 River Street, Hoboken, NJ 07030, [phone], fax [phone], or online at http://
www.wiiey.com/go/permission.
Limit of Liability/Disclaimer of Warranty: While the publisher and author have used their best efforts
in preparing this book, they make no representations or warranties with respect to the accuracy or
completeness of the contents of this book and specifically disclaim any implied warranties of mer-
chantability or fitness for a particular purpose. No warranty may be created or extended by sales rep-
resentatives or written sales materials. The advice and strategies contained herein may not be suitable
for your situation. You should consult with a professional where appropriate. Neither the publisher nor
author shall be liable for any loss of profit or any other commercial damages, including but not limited
to special, incidental, consequential, or other damages.
Wiley also publishes books in a variety of electronic formats. Some content that appears in print may
not be available in electronic formats. For more information about Wiley products, visit the web site
at www.wiley.com. For general information on other Wiley products and services or for technical sup-
port, please contact the Wiley Customer Care Department within the United States at [phone],
outside the United States at [phone] or fax [phone].
Library of Congress Cataloging-in-Publication Data is available.
ISBN 978-1-11829-122-1
Printed in the United States of America.
109 87 6 543 2 1
WILEY TIMS
A John Wiley & Sons, Inc., Publication
TABLE OF CONTENTS
Characterization of Minerals, Metals, and
Materials
Preface xiii
Editors xv
Characterization of Minerals, Metals, and Materials
Characterization of Ferrous Metals I
Characterization of the Microstructure of Compacted Graphite Cast Iron 3
V. Rastegar
EBSD Analysis of Complex Microstructures of CSP® Processed Low Carbon
Micro-Alloyed Steels 11
G Reip, R. Flender, andM. Frommert
Empirical Models of Cold Working Effect in Steel Tube Production 19
R. Batson, andJ. Zhang
Microstructural Investigation of Carbon Steel after Hot Rolling to Optimize
Complex Hot Forming of Thick Plates ..27
G. Tober, O. Anopuo, and P. Maier
Microstructural Characterization of Fe-Mn-C Ternary Alloy under Near-Rapid
Solidification 35
W. Xia, R. Yang, C. Song, and Q. Zhai
Effects of Surface Modifications on SCW Corrosion Resistance 43
J. Li, S. Penttilä, and W. Zheng
Interface Mass Transfer during the Tribofinishing Process 49
I. Hilerio, D. Medina, V. Cortes, andJ. Muñoz
v
Characterization of Non-Ferrous Materials
Improvement of Mechanical Properties in Severely Plastically Deformed
Ni-Cr Alloy 61
K. Song, H Kirn, H Son, and W. Kim
Processing and Microstructural Control of Copper Foams for Thermal Wick
Material Systems 69
K, Ledford, S. Lin, andJ. Nadler
Characterization of Minerals and Ceramics
A Novel Low»Energy Route for the Extraction of Copper And Cobalt
Metals/Alloys from the Zambian Sulphide Concentrates 79
K Hara, and A, Jha
Structural and Chemical Modification of Sulfide Mineral Surfaces by High-
Power Nanosecond Pulses 89
/. Bunin, V, Chanturiya, A. Kovalev, I. Khobar ova,
andE, Koporulina
Characterization of Magnetic and Non-Magnetic Iron Oxide Nanoparticles
Synthesized by Different Routes 99
A. Maich, E. Er dem, and F. Doyle
Characterization of Concentrate, Pellet and DRI Samples for Trace
Elements 107
M Zhang
The Dielectric and the Temperature-rising Characteristics of Ore Fines
Materials in Microwave Field 115
//. Zhu, L Dai, 1 Peng, W. Liang, Z Wei, Z Weng, Q. Ye,
andJ. Chen
Characterization on the Roughness of the Iron Ore Particles 123
X Lv, X. Huang, R. Zhang, andM. Zhou
Synthesis and Characterization of Al, Ag, Ti, Cu, and B Substituted
Hydroxylapatite , 131
C. Er gun, T. Webster, G. Gunes, A. Bahadir, H Liu, and l. Erden
Electric Resistivity of Fine Chromite Ore 139
C Pan, X. Lv, C. Bai, X. Liu, and D. Li
vi
Melting and Reduction of Manganese Sinter with Fluxes 147
T. Brynjulfsen, andM. Tangstad
Ceramic Pigments with Spinel Structure Obtained by Low Temperature
Methods 155
O. Restrepo, E. Chavarriaga, andL. Jaramillo
Mechanical Characterization of Cellular Ceramic Materials 163
W. Aechar, F. Bar celos, andL. Per eirá
Study of Attapulgite for Human Health 169
W. Aechar, T. Mow a, A. Costa, andL. Barret o
Characterization Technologies
3D Metallography of Multiphase Steels 177
M. Fischer, P. Lutomski, A. Stieben, and W. Bleck
Characterization of Open-Pored Metals Using Image Processing 185
B. Hinze, andJ. Roesler
Thermography Assisted Fatigue Testing 193
A. Saiga!, R. Gu, C. SanMarchi, andD. Matson
Characterization of Environmental and Construction
Materials
Tile Production Using Wastes from Mining Industry of the Mining District
Pachuca and Real Del Monte 203
J. Hernandez, E. Salinas, F. Patino, I. Rivera, J. Flores,
N. Trápala, M. Pérez, M. Flores, and I. Reyes
Concrete with Cementitious Steel Slag Composites and Its Applications 211
H. Fang, J. Hwang, G. Xue, andL. Lu
Characterization of Dust Generated in the BOF Converter 221
E. Junca, J. Oliveira, D. Espinosa, andJ. Tenorio
Experimental Research to Improve the Soundness of Cementitious Material
Blended with Cycled Fluidized Bed Ash 229
S. Zhu, andX. He
Vll
Production of Apatitic Material Using Turkish Colemanite Mineral 239
f . Moral, T. Basargan, and G. Nasun-Saygih
Setting Time of Concrete Material; Laboratory Measurements Versus Field
Applications 251
M Riad, S. Shoukry, and G. William
Gas Emission and Structural Changes in the Firing of Red Clay Ceramics with
Addition of Sanitary Ware Mass Wastes 259
R Faria, V. Souza, S. Cosin, R. Toledo, andH. Vargas
Characterization of Energy, Electronic and Optical
Materials
Influence of La 0 Additive Content on the Phase Stability, Sintering and
2 3
Microstructure of 8 MOL% Y 0 Stabilized Cubic Zirconia (8YSZ) Ceramic
2 3
Used for Solid Oxide Fuel Cell Applications 269
S. Tekeli, B. Aktas, andS. Salman
Development and Characterization of Carbonaceous Materials Incorporated with
Metal (Ti, V and Zn )-Organic Compounds for Hydrogen Storage 277
M Nath, A, Kumar, and A, Mallick
Characterization of Nickel Oxide Nanoparticles for Hydrogen Adsorption with
External Electric Field 285
Z. Zhang, X. Sun, Z. Peng, andJ. Hwang
Nanocrystalline CdS Thin Films Prepared by Vacuum Evaporation 293
5. Ikhmayies
Structure-Property Correlation of xPb(Nio.33Nbo.67)0-( 1 -x)Pb(Zr.3 iTi.69)O
3 0 0 3
Based Relaxor-Ferroelectric Ceramics Synthesized Via Columbite
Precursor Method 303
B. Mallesham, 71 Jayaraman, A. James, and D. Das
The Characteristics of Optical Recording Media Affected by the Accelerating
Aging Test... 311
D. Huang, J< Lin, T. Lin, J. Chen, M. Lin, andJ. Tsai
A Comparison between the Properties of Spray-Pyrolyzed Sn0:F/CdS:In
2
Structures Prepared by Using NHF and HF as a Source of Fluorine 319
4
S, Ikhmayies, and R. Ahmad-Bitar
Vlll